Filter
Top Products
14 en | Installing the High Speed Pan/Tilt High Speed Pan/Tilt System
F01U.073.990 | Version 1.0 | 2007.07 Instruction Manual Bosch Security Systems
11. Make a group with all signal cables and fix them with the tie thread. Figure 4.5 indicates a
proper cable connection.
Fig. 4.5 Tie Threads used to Group and Secure Signal Cables
4.2 Wiring the Video Cable
To wire the video cable, proceed as follows:
1. Strip the video cable with a pair of wire strippers.
2. Cut the length of the center conductor and the braid to approximatley 30 mm (1.2 in.).
3. Twist the braid into a single conductor.
4. Use a small screwdriver to press down on the GND push latch (see Figure 4.6) and attach
the single braid to the GND terminal.
5. Use a small screwdriver to press down on the VIDEO push latch (see Figure 4.6) and
attach the center conductor to the VIDEO terminal.
Fig. 4.6 Wiring the Terminal
Note: The above terminals support AWG 20 (0.5 mm
2
) to AWG 28 (0.08 mm
2
).