Filter
Top Products
22 en | Attaching the Top Unit High Speed Pan/Tilt System
F01U.073.990 | Version 1.0 | 2007.07 Instruction Manual Bosch Security Systems
6 Attaching the Top Unit
Each time the top unit requires re-assembling, the screw seals should be replaced (use a cali-
brated torque wrench setting of 2.1 Nm) to ensure the appliance remains water tight.
Inside the bottom cover there is a small bag containing mineral salts that are used to prevent
moisture formation in the base and near the connector boards. This salt does not require any
maintenance; however, remove the salt bag from the base before installing the unit.
To attach the top unit, proceed as follows:
1. Place the salt bag inside the housing as shown in Figure 6.1, with the salt bag secured
into position by the metal fixing accessory and two fixing screws (supplied in small box of
accessories).
Fig. 6.1 Salt Bag Placement
2. Remove the camera packaging material.
3. Make sure the gasket is present and in good condition.
4. Place the unit on the base. Align the tabs on the sides (see Figure 6.2) and verify that the
parts are positioned correctly. Be careful not to pinch any of the wires.
Reference # Description
1 Salt Bag
2 Metal Fixing Accessory
3 Fixing Screws