Filter
Top Products
VIP XD Configuration Using a Web Browser | en 31
Bosch Security Systems Installation and Operating Manual DOC | V4.0 | 2009.06
Resolution
You can enter the desired screen resolution in pixels here. On digital flat screens (LCD, TFT
and others) the optimum resolution corresponds to the actual number of pixels. Resolutions
up to 800 × 600 pixels are supported by default.
Refresh rate
Enter the desired refresh rate based on the technical specification of the monitor you are
using. For smooth video playback, the 50 Hz setting is recommended for PAL sources and the
60 Hz setting for NTSC sources.
Border top / bottom / left / right
You can place a frame around the video image to make it easier to see. The width of all four
borders can be adjusted individually. The color of the frame (gray tone) can be specified in
the Details window (see Section Details, page 32).
Horiz. spacing / Vert. spacing
For a quad view screen, as well as the outer frame you can define separating lines between
the different images. You can set the width of the horizontal and vertical separating lines
individually. The color is the same as the frame color.
Screen position
You can move the video image horizontally and vertically within the screen area. You can also
adjust the width and height of the video image.
1. Click one of the four arrows in the large monitor graphic to move the image in the desired
direction.
2. Click the plus or minus icons next to the small monitor graphics to change the size of the
image.
i
NOTICE!
For tube monitors, higher refresh rates may be advisable for ergonomic reasons. However, to
prevent damage to monitors that do not support these refresh rates, the exact monitor data
must first be set using the terminal program (see Section 8.7 Communication with Terminal
Program, page 67).
i
NOTICE!
If the horizontal or vertical scaling of the monitor image is changed, the new values for Hor.
scan rate and Dot clock are immediately displayed in the fields above the monitor graphics
for information. You cannot enter or change these settings in the actual fields.