Filter
Top Products
21
and Sensor Level parameters. Please note, the PIR is strongly sensitive to
ambient temperature. The greater the temperature dierence between
the environment and your subject, the farther the possible sensing
distance. The average sensing distance is about 45 ft.
Before leaving the camera unattended, please check for the following:
Are the batteries or DC power supply inserted/connected with •
correct polarity and is the power level is sucient?
Does the SD card have sucient available space and is its write-•
protection (lock) switch o?
Is the Power switch in the • ON position? (do not leave it in SETUP).
PLAYING BACK/DELETING the PHOTOS/VIDEOS
After you have setup, mounted and activated your Trophy Cam, you will
of course be eager to return later and review the images it has captured
for you. There are several dierent ways this can be done.
Reviewing Images on an External Video Monitor
A TV monitor can also be used to play back pictures (or videos) from
the device. Connect a TV monitor or a viewing device (such as a digital
picture frame) that has a standard composite video input (RCA jack) to
the Trophy Cam ‘s “TV Out” mini jack using the supplied cable. Then:
Put the power switch in • SETUP mode (switch to OFF rst).
Press the • OK key. The most recently captured image will be shown
on the video monitor. For video clips, press the SHOT (RIGHT) key to
start playing, press again to stop.
Press the • UP key for the previous photo or video and the DOWN
key for the next one. When viewing images, the total number of all
images in the SD card and the index of the displaying image are
shown in the center of LCD and at the bottom of the video monitor
respectively.
Press the • OK key to return to live preview state (SETUP mode) when
playback is nished.