Bushnell 119425C Digital Camera User Manual


 
26
Camera won’t power up
Make sure that you have installed at least 4 batteries (the required 1.
minimum #) in the battery compartment, starting at the top,
lling battery spaces 1-4 with no “gaps”.
Bushnell recommends using 8 Energizer® Lithium AA batteries
in all Trophy Cams.
Make sure that the batteries are installed correctly, observing 2.
proper polarity. Always place the negative (at) end of each
battery in contact with the spring side of its slot inside the
camera.
After moving the switch from “O” to “Setup” or “On”, make sure 3.
that the switch is correctly in position to ensure the proper mode
(avoid positions “between” two modes).
Do not move the switch directly from “On” to “Setup”-always 4.
move the switch all the way down to “O” rst, then back up to
“Setup”.
Still Photo and/or Video Quality Problems
1. Night photos or videos appear too dark
a. Check the battery indicator icon to see if battery power is full.
The ash will stop operating near the end of the battery life.
b. You will get the best results when the subject is within the
ideal ash range, no farther than 45’ (14m) from the camera.
Subjects may appear too dark at greater distances.
c. Please note that when the Capture Number parameter is set
higher than “1 Photo”, or with very short Interval settings, some
images may appear darker than others due to the quick response
and rapid retriggering of the camera, allowing less time for the
ash to fully recharge before ring again.
2. Daytime photos or videos appear too dark
a. Make sure that the camera is not aimed at the sun or other
light sources during the day, as this may cause the auto exposure
to produce darker results.
Troubleshooting / FAQ