Bushnell 119425C Digital Camera User Manual


 
25
Battery life is shorter than expected
Battery life will vary with operating temperature and the number 1.
of images taken over time. Typically, the Trophy Cam will be able
to capture several thousand images before the batteries die.
Check to make sure you have used new alkaline or lithium 2.
batteries. Bushnell recommends using 8 Energizer® Lithium AA
batteries in all Trophy Cams to obtain maximum battery life.
Make sure that the power switch was turned to the “On” position 3.
and that the camera was not left in “Setup” mode while in the
eld.
Make sure that you are using a good quality name brand SD 4.
card in your camera. Bushnell recommends SanDisk® brand SD
Cards up to 4GB. Our experience indicates that poor quality SD
cards can sometimes reduce your Trophy Cam battery life.
Camera stops taking images or won’t take images
Please make sure that the SD card is not full. If the card is full, the 1.
camera will stop taking images.
Check the batteries to make sure that they are new alkaline or 2.
lithium AA batteries. See note above about short battery life.
Make sure that the camera power switch is in the “On” position 3.
and not in the “O” or “Setup” modes.
Make sure that you are using a good quality SD card in your 4.
camera. Bushnell recommends SanDisk® SD Cards up to 4GB.
If the SD card has its write protect switch in the lock position, the 5.
camera will not take images.
If you have used an SD card in another device before inserting it 6.
in your Trophy Cam, you might want to try formatting the card
using the “Format” parameter in Setup mode (make sure you
have backed up any important les rst, as formatting will erase
all previous les). In some cases, other devices may change the
formatting of the SD card so that it will not work properly with
the Trophy Cam.
Troubleshooting / FAQ