Filter
Top Products
Operating Manual
12.
CR10X
the CS
e.
ents
12.2 CR10X Memory Allocation
Memory must be allocated in the CR10X for the purpose of storing files. The
mem y ultiples of 64Kbyte blocks. Memory allocated for file
storage comes out of final storage space. The files are stored in a circular buffer
(rin e l
storag m
The mem
ommend 6 to 16
blocks)
blocks required will vary with the compression level
e.
n
.
one selected as compression.
12.3 CR10X Pak
PakBus communications facilitate the transfer of images from the camera to the
datalogger. Several parameters must be set on the CR10X to enable PakBus
communications with the Camera.
These parameters can be set either with a CR10KD, using Edlog \ Options \
PakBus Settings, or even with the Device Configuration Utility using Terminal
Emulator mode.
CR10X Interface Guide
This section contains information for interfacing the CC640 camera to the
datalogger. The CC640 camera can interface to the CR10X datalogger via
I/O port directly or through an MD485 interfac
12.1 CR10X Datalogger Requirem
It is highly recommended that the datalogger be a 2Meg datalogger. The
datalogger must also contain the PakBus operating system to support the
communications and file storage capabilities.
or is allocated in m
g m mory). When new files are sent from the camera to the CR10X’s fina
e emory the oldest files will be deleted to make room for the new file.
ory can be allocated as follows:
• Enter *D16A
• 16:XX should be displayed. XX represents the number of 64 Kbyte
memory
blocks allocated for file storage.
• Enter the number of blocks required followed by A. (Rec
The number of memory
selected and the number of files required to reside in the dataloggers final storag
It is recommended to allocate between 6 to 16 memory blocks. If the compressio
level selected is none then 16 memory blocks (1024 kbytes) is recommended
Files can exceed 500Kbytes with N
Bus Settings
29