Filter
Top Products
Appendix B. Quick Set-up and Test
Procedure CC640 in Standalone Mode
PURPOSE: The steps below are designed to help first time users operate the
CC640 camera. The procedures are useful to do a quick check on the camera’s
operation and familiarize the user with focusing. These procedures are intended
for use only as an initial check of the CC640’s operation. It is recommended to
read the CC640 manual prior to deployment in the field.
STEP 1: Remove the CC640 and accessories from its packaging. Ensure the lens
is free from any dust and clean the lens using the cloths provided if necessary.
ACCESSORIES
Item Part Number
RS-232 interface ribbon cable, 10 pin female header to DB9 female C1946
CS I/O interface ribbon cable, 10 pin female header to DB9 male C1947
Finished 6 conductor cable, approximately 60cm (2 Feet) long Fin6Cond
Precision slotted screw driver 2.5mm (3/32”) wide L8125
Screws – ¼-20x3/8” Philips Pan Qty 3 C2002
Screws – 4-40x3/8” Philips Pan Qty 4 L467
Lens wipes N/A
B-1