Open as PDF
Still Images Movies
Customizing the Self-Timer
You can specify the delay (0 – 30 seconds) and number of shots (1 – 10).
1 Choose [$].
Following step 1 in “Using the Self-Timer”
31), choose [$] and press the
2 Congure the setting.
Press the <o><p> buttons to choose
[Delay] or [Shots].
Press the <q><r> buttons to choose a
value, and then press the <m> button.
Once the setting is complete, [$] is
Follow step 2 in “Using the Self-Timer”
31) to shoot.
• For movies shot using the self-timer, [Delay] represents the delay
before recording begins, but the [Shots] setting has no effect.
• When you specify multiple shots, image brightness and white balance are
determined by the rst shot. More time is required between shots when the
ash res or when you have specied to take many shots. Shooting will stop
automatically when the memory card becomes full.
• When a delay longer than two seconds is specied, two seconds before the
shot, the lamp blinking and self-timer sound will speed up. (The lamp will
remain lit in case the ash res.)
Deactivating the Flash
Prepare the camera for shooting without the ash as follows.
Press the <r> button several times until
[!] is displayed.
The ash will no longer be activated.
To activate the ash, press the <r>
button again. ([
] is displayed.) The
ash will automatically re in low-light
• If a blinking [
] icon is displayed when you press the shutter button
halfway in camera-shake inducing, low-light conditions, mount the
camera on a tripod or take other measures to keep it still.
Downloaded From camera-usermanual.com Canon Manuals