Filter
Top Products
Additional Information
94
WHILE THE CAMCORDER IS CONNECTED TO A PC DO NOT DISCONNECT THE USB CABLE OR POWER SOURCE
CANNOT TURN OFF POWER OR CHANGE MODES
- When the camcorder is in mode and is connected to the computer with a USB cable, the camcorder
cannot be operated. Disconnecting the USB cable or power source while this message appears may result in
permanent loss of the recordings in the camcorder. Use the computer’s Safely Remove Hardware function to
end the connection and disconnect the USB cable before using the camcorder.
Messages Related to the Optional DW-100 DVD Burner
If a message appears while the camcorder is connected to the optional DW-100 DVD
Burner, refer to the following section and also to the instruction manual of the DVD
burner.
CANNOT READ THE DISC CHECK THE DISC
- During disc recording mode, this message can appear when a commercially available DVD disc (a DVD disc
containing movies, software, etc.) or an 8 cm mini DVD disc is inserted.
- During disc playback mode, this message can appear when a commercially available DVD disc or a brand
new DVD disc is inserted.
CLOSE THE MEMORY CARD SLOT COVER
- The memory card slot cover is open. Close the cover after correctly inserting the memory card ( 27).
CONNECT THE COMPACT POWER ADAPTER
- The camcorder is being powered by the battery pack. Connect the compact power adapter to the camcorder.
DISC ACCESS FAILURE CHECK THE DISC
- There was an error when reading the disc or attempting to write onto it.
- This message can also appear if condensation has formed. Wait until the DVD burner dries completely before
resuming use ( 100).
- The disc may not be loaded correctly. Try removing the disc and reinserting it.
ERROR READING THE DATA
- Error while reading the recordings from the camcorder.
- Check that the USB cable was not accidentally disconnected.
LOADING THE DISC
- Reading data from the disc.
NO DISC
- Insert a disc into the DVD burner.
- This message can also appear if condensation has formed. Wait until the DVD burner dries completely before
resuming use ( 100).
NO PHOTOS
- There are no photos to add to the disc.
NO SCENES
- There are no movies to add to the disc.
NO TRANSFER ORDERS
- You selected to create a DVD with the [TRANS.ORD] setting, but no photos have been marked with transfer
orders ( 74).