Filter
Top Products
50
E
Using the Full
Range of Features
To prevent interference from other
Canon wireless controllers being used
nearby, there are 2 remote sensor
modes and an off setting. The wireless
controller and the camcorder have to be
set to the same mode in order to be
compatible.
To turn the remote sensor off:
Open the menu and select SYSTEM. Then select WL.REMOTE, set it to
OFF
B
and close the menu.
• B appears in the display.
To change the mode...
...on the camcorder:
Open the menu and select SYSTEM. Then select WL.REMOTE, set it
to A 1 or A 2 and close the menu.
• The selected mode will appear on the display for 4 seconds.
...on the wireless controller:
Press and hold the REMOTE SET button on the wireless controller.
Simultaneously press the ZOOM W button for mode 1 or the ZOOM
T button for mode 2. Continue to press simultaneously for over 2
seconds.
• Be sure to set the wireless controller to the same mode as the camcorder.
A 1 : Mode 1
A 2 : Mode 2
OFFB : Sensor off
WL.REMOTE••• 1
SYSTEM
( 40)
The wireless controller and the camcorder have been preset to mode 1. If you
change the mode on the camcorder, be sure to change the mode on the wireless
controller to the same mode.
REMOTE SET
ZOOM
WT
+
,
+
,
+
,
+
PLAY
(VCR)
CARD
CAMERA
CARD
PLAY
(VCR)
TAPE
CAMERA
TAPE
When Operating 2 Canon DV Camcorders (Remote Sensor Mode)
#3_ MV550i/530i__E(39-86) 1/9/02 14:48 Page 50