Canon SD500 Digital Camera User Manual


 
20
• Since this is a lithium-ion battery pack, you need not completely
discharge it before recharging. It can be recharged at any point.
However, since the maximum number of charge cycles is
approximately 300 times (battery life based on Canon’s testing
standards), you are recommended to charge the battery pack after
having discharged it completely to prolong battery life.
• It takes approximately 95 minutes to fully charge the battery pack
from a fully discharged state (based on Canon’s testing standards).
Charging it within a temperature range of 5° to 40 °C (41° to 104 °F)
is recommended.
• Charge times may vary according to the ambient temperature and
the battery pack’s charge state.
• You may hear a noise during charging. This is not a malfunction.
•See Battery Capacity (Battery Pack NB-3L (Fully charged)) (p. 177).
Battery Pack Handling Precautions
zKeep the battery pack terminals ( ) clean at all times. Dirty
terminals may cause poor contact between the battery pack and camera.
Polish the terminals with a soft cotton swab before charging or using the
battery pack.
zDo not rapidly overturn or wave the battery charger around when it
contains the battery pack. The battery pack could fly out.
zAt low temperatures, battery pack performance may be reduced and the
low battery icon may appear earlier than usual. Under these conditions,
resuscitate the battery pack by warming it in a pocket immediately before
use. However, ensure that there are no metallic items in the pocket that
could cause a short circuit, such as a key holder, etc.
zDo not place anything, such as tablecloths, carpets, bedding or cushions,
on top of the battery charger while it is charging. Heat will build up and
could result in a fire.
zDo not charge batteries other than Battery Pack NB-3L in this charger.
zThe battery pack continues to discharge a minimal portion of its power
while installed in the camera, even with the power off, or in the charger.
This will shorten battery life.