Filter
Top Products
Additional
Information
E
118
Refer to page 87.
Appears when you try to do
audio dubbing or AV insert on a
tape recorded in any mode other
than SP mode(p. 37).
Appears when you try to do
audio dubbing on a tape
recorded in 16-bit audio or 12-
bit 4-channnel mode (p. 88).
Appears when the camera
detects a blank section of a tape
during audio dubbing or AV
insert (p. 91).
Appears immediately after you
start recording, and the video
heads are badly contaminated.
Make sure to clean the video
heads when this caution appears
(p. 105).
SET THE TIME ZONE,
DATA AND TIME
CHECK THE LENS
TER INGEN ”PO ERWTANDBY”S
C
HA
NGE
T
HE
BA
TT
E
R
YPAC
K
CHECK
THE DV NPUTI
TAPE END
E
TA
P
EI
S
E
R
T
H
A
SET FOR
URS
E
P
R
EENVT
I
O
N
CONDENSATION
HAS BEEN DET CTEDE
REMOVE THE CAS ETTES
R
ECOPY DPROTECT
CTED
RIGHT
PLAYBACK I S STR IE
R
ECOPY DPROTECT
CTED
RIGHT
DUBB I NG STR IE
CHECK THE CASSETTE
[
REC MODE
]
CHECK THE CASSETTE
[
AUDIO MODE
]
CHECK THE CASSETTE
[
BLANK
]
HEADS DIRTY,
USE CLEANING CASSETTE
Caution phrases
The camera displays various caution phrases —
they appear for 4 seconds before disappearing.
Appears each time you turn the
power on, until you set the time
zone, date and time (p. 32).
Refer to pages 14-15.
Refer to page 35.
Appears when the battery pack
is exhausted (p. 20, 98).
Appears when the tape has
reached the end.
Refer to page 23.
Appears when you press the 2
(record) button if the DV cable
is not connected properly
(p. 65).
Refer to page 106.
Appears as a warning to protect
the tape and also when
condensation is detected.
Remove the tape as soon as
possible after the camera has
displayed the caution.
Refer to page 87.