Filter
Top Products
Editing
E
96
a) Press the AUDIO MONITOR button to display
“STEREO1”, “STEREO2”, and “MIX”, each in
turn.
• Your choice is selected a few seconds after you
last pressed the button.
If you choose “MIX” you can go on to mix the balance.
• Use the MIX BALANCE ST-1, ST-2 keys to mix the balance. A bar showing the mix appears in the
viewfinder for 4 seconds.
Set the audio output in two main stages: (i) Selecting the audio mix
(ii) Choosing the output channel
(i) Selecting the audio mix
When you play back a tape that was recorded in 12 bit mode, you can select the output:
Stereo 1, Stereo 2 (4 channel recording or audio dubbing), or a mixture of the two.
• Audio from the 16 bit mode only contains stereo 1 sound, therefore it is not possible to select the audio
mix. The same is true for the 12 bit stereo 1 mode, unless new sound has been added post-recording. Go
directly to stage (ii).
• You only need to release the fixed level (step 2) if your aim is to mix the balance.
MIX SELECT•• VARIABLE
VCR SET UP
Selecting the Audio Output
L
R
V
S
L
R
AUDIO
MONITOR
STEREO1 MIXSTEREO2
1. Set the camera to VCR mode.
2. Release the fixed level (for audio mixing only).
(see p. 28)
a) Open the VCR menu and select VCR SET UP.
b) Select MIX SELECT, then select the VARIABLE setting.
c) Close the menu.
3. Choose the output.