Filter
Top Products
45
9
While looking at the blinking AF
point, press the shutter button.
•
Follow steps 4 to 6.
s
The AF point will blink in the following
sequence: 5 → 6 → 7 → 8.
10
Check the viewfinder display.
s
When the calibration is completed,
the CAL No. will stop blinking and
“i” will be displayed.
11
Set the Eye Control switch to
<g>.
•
This completes the calibration
procedure, and you can now use Eye
Control (p.48) to take pictures.
•
If you do the calibration procedure only for the horizontal orientation, Eye
Control during vertical picture-taking might not be so accurate. Be sure to
also complete the calibration procedure for the vertical orientation.
• If you interrupt the calibration procedure, wait until the AF point in the
viewfinder stops blinking, then start over from step
3.
• If the calibration does not go well, see “Eye Control Calibration Operation
Tips” (p.46).
• If the beeper setting (p.74) is set to “W”, the beeper will not sound.
If the camera does not detect your eye movement properly during the
calibration, the beeper will sound and the CAL No. will blink on the LCD panel.
In such a case, press the shutter button and start from step
3.
5
6
78