Filter
Top Products
23
Preparing the Wireless Controller and
Accessories
First, insert the supplied lithium button
battery CR2025 into the wireless
controller.
1 Press the tab in the direction of
the arrow and pull out the battery
holder.
2 Place the lithium button battery
with the + side facing up.
3 Insert the battery holder.
Point the wireless controller at the
camcorder’s remote sensor when
you press the buttons.
NOTES
• The wireless controller may not work
properly when the remote sensor is
situated under strong light sources or
direct sunlight.
• If the wireless controller does not work,
check that [WL.REMOTE] is not set to
[ OFF ] ( 49). Otherwise,
replace the battery.
• When the optional Tele-converter or
Wide-converter is attached to the
camcorder, it may partially obstruct the
remote sensor. Use the wireless
controller from a different angle.
Accessories
1 Fasten the grip belt.
Adjust the grip belt so that you can
reach the zoom lever with your index
and middle fingers, and the
button with your thumb.
2 Attach the optional shoulder strap.
Tab
START/STOP
D122_NTSC_E.book Page 23 Thursday, July 19, 2007 6:43 PM