Filter
Top Products
97
Direct Print Related Messages
About Canon PIXMA/SELPHY DS Printers: If the printer’s error indicator flashes or an error
message appears on the printer’s operation panel, refer to the printer’s instruction
manual.
CARD ERROR A memory card error occurred. The camcorder cannot record or display the
image. If after the message disappears appears in red, perform the
following: Turn off the camcorder; remove and reinsert the memory card and
set the camcorder back to mode.
If turns back to green you can resume recording/playback. Otherwise,
initialize the memory card. (Doing so will erase all the still images on the
memory card.)
76
CARD FULL Memory card is full. Erase some images to free some space or replace the
memory card.
69
THE CAMCORDER IS SET TO STILL
IMAGE MODE
You pressed while recording still images ( mode). –
NAMING ERROR The folder and file numbers have reached their maximum value. Set the
[FILE NOS.] option to [RESET] and erase all the images on the memory card or
initialize it.
–
TRANSFER ORDER ERROR You attempted to set more than 998 transfer orders. Reduce the number of
still images marked with transfer orders.
90
TOO MANY STILL IMAGES
DISCONNECT USB CABLE
Disconnect the USB cable and decrease the number of still images on the
memory card to fewer than 1,800. If a dialog appeared on the computer
screen, close it and then reconnect the USB cable.
–
WHILE THE CAMCORDER IS
CONNECTED TO A PC DO NOT
DISCONNECT THE USB CABLE OR
POWER SOURCE
CANNOT TURN OFF POWER OR
CHANGE MODES
When the camcorder is in mode and is connected to the
computer with a USB cable, the camcorder cannot be operated. Disconnecting
the USB cable or power source while this message appears may result in hard
disk damage. Use the computer to end the connection before disconnecting
the cable.
–
CONNECT THE COMPACT POWER
ADAPTER
When the camcorder is in mode and is connected to the
computer, this message will appear if the camcorder is being powered by the
battery pack. Connect the compact power adapter to the camcorder.
–
BACK UP RECORDINGS
REGULARLY
This message may appear when you turn on the camcorder. In the event of a
malfunction, recordings may be lost so back up your recordings regularly.
40
Message Explanation
PAPER ERROR There is a problem with the paper. The paper is not correctly loaded or the paper size is
wrong. Alternatively, if the paper output tray is closed, open it to print.
NO PAPER Paper is not correctly inserted or there is no paper.
Message Explanation
START/STOP
D122_NTSC_E.book Page 97 Thursday, July 19, 2007 6:43 PM