Filter
Top Products
O About the LCD and viewfinder screen: The screens are produced with
extremely high-precision manufacturing techniques, with more than
99,99% of the pixels operating to specification. Less than 0.01% of the
pixels may occasionally misfire or appear as black or green dots. This has
no effect on the recorded image and does not constitute a malfunction.
O The camcorder will shut off after 5 minutes when left in record pause
mode to protect tape and video heads, "_AUTO POWER OFF" appears
20 seconds before shutoff. To continue recording, turn the POWER switch
to OFF and then back to CAMERA,
O Wait until the tape counter stops completely before you start recording.
O When you do not remove the cassette, you can record the next scene without
producing any noise or blank sections between the recordings even if you turn
the camcorder off.
O Bright light may make itdifficult to use the LCD screen. In such case, use the
viewfinder instead.
O When recording near loud sounds (such as fireworks, drums or concerts),
sound may become distorted or may be recorded not in the actual sound level.
This is not a malfunction.
A!!o ing the Subject to M nitQ the LCD Screen.............................................................................................
You can rotate the LCD panel so that the screen faces in the I
same direction as the lens. The viewfinder switches on allowing I
you to use the viewfinder while the subject can monitor the I
screen. I
The image appears mirror reversed (LCD MIRROR ON). I
However, you can choose to display the image as it is being
recorded (LCD MIRROR OFF).
MENU DISPLAY SETUP/_
(_ 38)
]_> LCD MIRROR...ON
1. Press the MENU button to open the menu.
2. Turn the SET dial to select [DISPLAY SETUP/_)] and
press the SET dial.
3. Turn the SET dial to select [LCD MIRROR] and press
the SET dial.
4. Turn the SET dial to select [OFF].
5. Press the MENU button to close the menu.
26