Filter
Top Products
Audio Recording
Changing the AudiQ MQde _ [-_
You can record sound in two audio modes--16-bit and 12-bit. The 12-bit mode records
sound on two channels (stereo 1), leaving 2 channels free (stereo 2) for adding new
sound later. Select the 16-bit mode for higher sound quality.
I
A00,0sEToP] [AO0,OMOOE...12b tJ
Open the menu and select [AUDIO SETUP]. Select [AUDIO MODE], set it
to [16bit] and close the menu.
"16bit" appears for approximately 4 seconds.
Using HeadphQnes during ReCording
The headphones terminal also serves as AV terminal. Headphones can only be used
when "O" is displayed on the screen. If not, change the setting following the procedure
below.
I
1 m
_WENU VCR SETUP _AV/PHONES 9 • • AV
(_ 38)
J[
J
Open the menu and select [VCR SETUP]. Select [AV/PHONES 9], set it to
[PHONES Q] and close the menu.
MENU AUDIO SETUP
(C_38)
Open the menu and select [AUDIO SETUP]. Select [9 VOLUME], adjust
the volume with the SET dial and close the menu.
Youcan turn off the volume completely byturning the SET dial down until [OFF] appears.
Turn the SET dial up to increase the volume again.
=tl
==
¢n
61