Filter
Top Products
List of Messages
Message Explanation
SET THE TIME ZONE, You have not set the time zone, date and time. This message 22
DATE AND TIME appears each time you turn the power on until you set the time
zone, date and time.
CHANGE THE BATTERY Battery pack is exhausted. Replace or charge the battery pack. 13
PACK
THE TAPE IS SET FOR Cassette is protected. Replace the cassette or change the 144
ERASURE PREVENTION 3osition of the protect switch.
REMOVE THE Camcorder stopped operating to protect the tape. Unload and 16
CASSETTE reload the cassette.
CHECK THE INPUT DV cable or USB cable is not connected, or the connected digital 83
device is turned off.
CONDENSATION HAS Condensation has been detected in the camcorder. 142
BEEN DETECTED
TAPE END Tape reached the end. Rewind the tape or replace the cassette. -
CHECK THE CASSETTE You attempted to perform audio dubbing on a tape recorded in a 85
[REC MODE] mode other than the SP mode.
CHECK THE CASSETTE You attempted to perform audio dubbing on a tape recorded in 16- 85
[AUDIO MODE] bit or 12-bit 4-channel sound.
CHECK THE CASSETTE You attempted to perform audio dubbing on a tape with a blank 85
[BLANK] section.
WRONG FORMAT You attempted to play back a tape recorded in HD format. -
PLAYBACK NOT
POSSIBLE
CHECK THE CASSETTE You attempted to perform audio dubbing on a tape recorded in HD -
[WRONG FORMAT] format.
HEADS DIRTY, USE Video heads are dirty. Clean the video heads. 142
CLEANING CASSETTE
COPYRIGHT PROTECTED You attempted to play back a copyright protected tape. 82
PLAYBACK IS RESTRICTED
COPYRIGHT You attempted to dub a copyright protected tape. May also appear 82
PROTECTED DUBBING when an anomalous signal is received during analog line-in
RESTRICTED recording, or during analog-digital conversion of a copyright
protected tape.
MemQry Card Re!ated Messages
Message Explanation [_
NO CARD Memory card not is inserted into the camcorder. 89
THE CARD IS SET FOR SD Memory Card is set for erasure prevention. Replace the card 89
ERASURE PREVENTION or change the position of the protect switch.
NO IMAGES No images are recorded on the memory card. -
CARD ERROR A memory card error occurred. The camcorder cannot record or -
play back the image.
The error may be temporary. If the message disappears after 4
seconds and "E]_" flashes red, turn the camcorder off, remove
the card and reinsert the card. If "F=d" changes to green, you can
continue recording/playback.
CARD FULL No remaining capacity on the memory card. Replace with another -
card or erase images.
NAMING ERROR File or folder number has reached the maximum value. 92
138