Filter
Top Products
Adjusting the Volume
When you use the LCD screen for playback, the camcorder plays back the sound via
built-in speaker. The speaker does not sound when you close the LCD panel. Use
headphones when using the viewfinder.
SET dial
_h,(phones) terminal
Speaker
"bOO
The headphones terminal also serves as AV terminal. Headphones can only be used
when "Q" is displayed on the screen. If not, change the setting following the procedure _"
below. _=
I
1
MENU VCR SETUP I_ AVIPHONES Q ..AV
([_ 38)
J
Open the menu and select [VCR SETUP]. Select [AV/PHONES f}], set it to
[PHONES Q] and close the menu.
O The speaker does not sound when "Q" is displayed.
O Do not connect headphones unless "f'_" is displayed as it produces noise.
Adjusting ,,the.... me
i I
Turn the SET dial up to increase the volume, and down
to lower the volume.
• A volume bar appears for 2 seconds.
• You can turn offthe volume completely by turning the SET dial
down until [OFF] appears. Turn the SET dial up to increase the
volume again.
35