Filter
Top Products
[Server] Setting the Video Server, Audio Server and HTTP Server
61
5
Setting Page
HTTP Server
(1) [Authentication Method]
Set the authentication method used with the HTTP
server to [Basic Authentication] or [Digest
Authentication].
(2) [HTTP Port]
Set the HTTP port number to 80 or in the range of
1024 to 65535.
Normally [80] (factory default setting) is used.
(3) [HTTPS Port]
Set the HTTPS port number to 443 or in the range of
1024 to 65535.
Normally [443] (factory default setting) is used.
Caution
Switch line in and microphone in on each setting page
according to the specification of the microphone (p. 60).
Using the wrong input may damage the camera and/or
microphone. Be sure to configure settings correctly.
Important
• When multiple viewers are connected to the camera over an
SSL connection and audio is received from the camera, the
video frame rate may slow down and the sound may drop
out.
• The volume, sound quality, etc., may change depending on
the characteristics of the microphone used.
• If [Input Volume] or [Echo Canceller] settings are changed after
setting volume detection, check the detection setting again.
• Connect a speaker with amplifier to the camera (“Installation
Guide” > “Audio Input/Output Terminals”).
• If [Enable] is selected under [Echo Canceller], the sound
quality or volume may be affected. Utilize this function as
necessary according to the installation environment and how
the camera is used.
• When sending audio, carefully read the information in
“Important” under “Audio Input/Output Terminals” in the
“Installation Guide”.
• Audio Reception
• Output Volume
Important
If the setting of [HTTP Port] or [HTTPS Port] is changed, the
camera may become inaccessible from the active web
browser. Check beforehand the precautions in “Important” in
“[Reboot Item] Setting Items Requiring Rebooting” (p. 76).