Filter
Top Products
135
Using the Camera with a Computer
4. Turn off the camera
and then use the
USB cable that
comes with the
camera to connect it
to your Macintosh.
• The camera does not
draw power over the
USB cable. Make
sure the camera’s
battery is sufficiently
charged before
connecting.
• Make sure that you
insert the cable
connector into the
USB/AV port until you
feel it click securely
into place. Failure to
insert the connector fully can result in poor communication or malfunction.
• Note that even while the connector is fully inserted, you
still will be able to see the metal part of the connector as
shown in the illustration.
• When connecting the USB cable to a USB port, make
sure you align the connector correctly with the port.
• Your computer may not be able to recognize the camera if you connect via a
USB hub. Always connect directly to the computer’s USB port.
5. Turn on the camera.
The camera’s back lamp will light green at this time. In this mode, your Macintosh
recognizes the memory card loaded in the camera (or the camera’s built-in
memory if it does not have a memory card loaded) as a drive. The appearance of
the drive icon depends on the Mac OS version you are using.
6. Double-click the camera’s drive icon.
7. Drag the “DCIM” folder to the folder to which you want to copy it.
USB port
USB cable
Making sure that the 2 mark
on the camera is aligned with
the 8 mark of the USB cable
connector, connect the cable to
the camera.
USB/AV port
Large connector
Small connector