Filter
Top Products
TROUBLESHOOTING
E-111
1. Batteries not loaded correctly.
2. Dead batteries
3. Wrong AC adaptor
4. Lens cover is not completely open.
1. Auto Power Off
2. Low battery power
3. Use of manganese batteries.
Batteries are about to go dead.
1. The lens cover is closed.
2. Flash unit is charging.
3. The message “MEMORY FULL” is on the moni-
tor screen.
4. Insufficient memory card capacity or no memory
card loaded in camera.
1. Lens is dirty.
2. The object you want to focus is not in the focus
frame.
3. Conditions make it impossible to obtain proper
focus.
4. Camera is unsteady or shaking.
TROUBLESHOOTING
Symptom
Probable Cause
Action
Power Supply
Recording
No power
Sudden power failure
“ ” indicator on LCD
No recording when shutter
button is pressed
Auto Focus cannot focus
the image.
1. Correctly load batteries (page E-35).
2. Replace all four batteries with a set of new ones
(page E-35).
3. Use only recommended AC adaptor .
4. Completely open the lens cover.
1. Turn power back on.
2. Replace all four batteries with a set of new ones
(page E-35).
3. Replace manganese batteries with alkaline,
lithium or Ni-MH batteries.
Replace all four batteries with a set of new ones
(page E-35).
1. Slide open the lens cover.
2. Wait until flash unit charging is finished.
3. Delete images you no longer need from camera
memory.
4. Load a memory card.
1. Clean off the lens.
2. Aim the camera so the object you want to focus
is in inside the focus frame.
3. Switch to the Manual Mode and focus manually.
4. Use a tripod to steady the camera.