Filter
Top Products
• After the font LCD screen has powered on. Press the
[TEST] button (this must be done with in 30 seconds
or the camera will enter count down mode)
• Close the front housing.
• Walk around in the front of the camera to see if you
have mounted camera in the proper position. A green
indicator light on the front will blink on when you
have intruded the coverage area.
• Adjust the camera position as needed and repeat
testing until the desired coverage area is achieved.
• When you have completed the testing the coverage
area there are 2 methods for exiting the test mode:
a. Open the front housing and press the [TEST]
button to exit test mode. The camera will then
enter count down mode for 1 minute and front
green indicator will start blinking giving you one