Filter
Top Products
41
Preset Function Area
”Enable IR control” Checking this box allows the Administrator to enable the IR
controller to move the aim of the camera. To allow controls only through URL
commands or web pages, leave this box unchecked.
”Current position”, If the User wants to save the current view as a preset location,
enter a name for each of the current video view at “current position” and click on the
“Add” button. The camera allows for 20 preset locations.
”Preset position” This keeps a list for preset positions. Clicking on the “Delete”
button will remove the current selected position from the preset list.
”Dwelling time” The value set here specifies:
1. The stop time of each preset location during auto patrol of the Network Camera.
2. The stay time at the most left and the most right positions when the Network
Camera is doing auto panning.
”Patrol selection”, After the User has saved a list of preset positions, the “Preset
locations” box will also keep a list of the preset positions. And once the “Select>”
button is clicked, the “Selected location” box will keep a list of the patrol stops. The
“Remove” button removes the preset position from the patrol stops. The “UP”, “DOWN”
buttons adjust the order of the patrol stops. Several preset positions can be added to
the patrol stops. The camera can accept up to 40 patrol stops.
“Save” button
The button is valid for “Pan speed”, “Tilt speed”, “Auto pan/patrol speed”, “Enable IR
control”, “Dwelling time” and “Patrol selections”. In other words, after changing these
settings, and the “Save” button is not clicked, the new setting of the camera will not
take effect.