Filter
Top Products
36D-Link DCS-5222L User Manual
Section 4 - Conguration
Wireless Setup
To set up your Network camera’s wireless network interface settings, enable Wireless Settings in this window rst.
Check the box to enable wireless functionality or
uncheck the box to disable wireless functionality.
Click the Rescan button to scan for available wireless
networks. After scanning, select a wireless network from
the drop-down box that you want to connect to.
The name of the wireless network.
Use the drop-down box to select the mode of the
wireless network you wish to connect to. Infrastructure
is normally used to connect to an access point or router.
Ad-Hoc is usually used to connect directly to another
computer.
If you are using Ad Hoc mode, select the channel of the
wireless network you wish to connect to, or select Auto.
Select the type of authentication you are using on your
wireless network (Open, Shared (WEP), WPA-PSK, or
WPA-PSK2).
If you are using WPA-PSK or WPA-PSK2 authentication,
you will need to specify whether your wireless network
uses TKIP or AES encryption. If you use Open or Shared
authentication, this setting will be automatically set.
Enter the key or passphase to access a secure network.
Enable Wireless:
Site Survey:
SSID:
Wireless Mode:
Channel:
Authentication:
Encryption:
Key:
After making any changes, click the Save Settings button to save your changes, or click the Don’t Save Settings button to discard your changes.