Filter
Top Products
17D-Link DCS-931L User Manual
Section 2 - Installation
To create a WPS connection:
Step 1
Make sure the camera is plugged in, then press and hold the WPS button for
three seconds. The blue WPS status LED will start blinking.
Step 2
Press the WPS button on your router within 60 seconds. The WPS button is
usually on the front or side of your router. On some routers, you may need
to log in to the web interface and click on an on-screen button to activate
the WPS feature. If you are not sure where the WPS button is on your router,
please refer to your router’s User Manual.
The DCS-931L will automatically create a secure wireless connection to your
router. While connecting, the green LED will ash and your camera will reboot.
WPS - Push Button Setup
WPS Button
Alternatively, you may create a secure wireless connection using the WPS Button on the back of the camera.