Filter
Top Products
107
４
4 TROUBLE SHOOTING
4-1 Symptoms and Confirmation
Check the following items. If any abnormality is found, consult the dealer from whom you
purchased this product or our nearest branch/office.
Symptom
Possible cause/ remedy
No image is displayed. • The cable is not correctly connected.
• The AC adapter is disconnected from the wall outlet.
• The AC adapter is disconnected from the power supply socket
of the unit.
• The power is not ON. (Blue light)
• Zoom is set at the TELE side, displaying only the white/black
part of the document.
• If you turn the power ON immediately after turning it OFF, the
unit may not start. Wait for several seconds after turning the
power OFF, and then turn it back ON.
• The slide switch is not set to the correct image output
(RGB/HDMI). Set the “RGB/HDMI Switch” correctly.
• Reconnect the AC adapter.
The output image (resolution)
changes automatically.
• When the HDMI monitor is connected, the output image
(resolution) is automatically changed based on information
from the connected monitor.
No image is displayed from
the USB.
• No image is output from USB when USB mode is set to mass
Storage or in Play mode or in Recording mode or when using
the Compare Picture Function. Switch the USB mode from
Mass Storage to Application by referring to [ (Setting)]
> [ ] on the touch panel. When using Play mode,
change the output image to Camera image.
The image is out of focus.
• The document (object) is too close to the lens. Move the
document (object) slightly away from the lens.
• Auto focus may have difficulty in adjusting correctly. Focus on
an image manually by referring to “Manual focus”.
The image is too dark. • The intensity of the lighting is insufficient. Tap [ (Main
menu)]>［ ］on the touch panel or press the [ ]
button on the remote control to adjust the brightness.