Elmo P100HD Digital Camera User Manual


 
7
BEFORE YOU USE
The power cord and AC adapter that come with this product are for this product only. Do not use
them with another product.
Be sure to use the power cord applicable to your local power specifications.
When storing the product, do not leave it under direct sunlight or by heaters. It may become
discolored, deformed, or damaged.
Do not place this product in any humid, dusty, salt bearing wind, or vibrating locations.
Only use it under the following environmental conditions:
Temperature: 0°C - 40°C (32°F - 104°F)
Humidity: 30% - 85% (No condensation)
Do not move the camera column or the lamp column while your finger is being placed between the
camera column and the lamp column. Otherwise, your finger may be pinched and injured.
In handling (including setting up and storing) or carrying the camera, be meticulously careful not
to give an impact on the camera head.
Use a soft, dry cloth for cleaning.
Do not use any volatile solvent such as thinner or benzene.
Do not point the camera lens directly at the sun. It may be damaged and you may not be able to
take pictures.
Luminescent and Black Spots
There may be some pixels that do not properly operate due to the use of CMOS Area Image
Sensors made-up of many pixels.
Though luminescent or black spots may be found on the screen, it is a phenomenon peculiar to
the CMOS Area Image Sensors and is not a malfunction.
To prevent damage during transport, a protection sheet has been put on the touch panel screen.
Please be sure to remove it before use.
Do not press the panel strongly by finger or sharp objects.
This can cause damage or malfunction.
Follow the guidelines below to prevent the unit from dropping or overturning.
Use the product on a stable base, desk, or table. Do not place the product on an unstable
base or slanted surface.
Place or wire the unit to prevent the AC adapter cord or video cable from pulling.
Carry the product by holding the lower part of the main unit in both hands. Never hold the
product by the column or the camera head.
Pay careful attention when using (including setting-up and storing) or transferring the product to
prevent the camera head from receiving any shocks.
Do not look directly into the LED light. If you look directly into it at point-blank range, your eyes
may be injured.
Some type of SD card/USB flash drive can be used.