Filter
Top Products
26
English
OPERATION
PROCEDURE
Presentation using an optional SD card (Option)
Note
• Before starting the operation, insert an optional SD card (Option) into the SD slot on
the side panel. Push the card again to remove the SD card.
•
Insert the SD card with the labeled side up. Forcing it in the wrong way may cause a malfunction.
•
When loading or unloading the SD card or the power is turned OFF, be sure to select
the camera image by pressing the camera button [
] on the front operating panel
and confirm that the output image has been turned to the camera image beforehand.
Otherwise, the SD card contents could be broken or failure could be caused to the camera.
• The SD card is composed of parts vulnerable to static electricity. Therefore, due to
static electricity, the SD card could malfunction or its contents could be destroyed.
When handling the SD card, take care to avoid static electricity.
• The image data viewable on this product is limited to the image data saved in this
product and the image data converted using the conversion function of the software
attached to this product.
• If you try displaying the image data whose format is not compatible with this product, a
black or gray image will be displayed.
•
If you try displaying the image data in the SD card without inserting the SD card, a black
image will be displayed. (The message “NO CARD” will appear on the screen.)
• After using the SD card, do not leave it inside this product, but be sure to remove it.
• Panasonic SD card (256MB or 512MB) is recommended. The resolution of the image
to be stored is 1024 x 768 (XGA output).
This product can store images up to 2048 pcs.
• ELMO is not liable for any damage caused by the loss of the data in the SD card or
passive damage.
•
This product is not compatible with SDHC cards. Use a card recommended for this product.
•
When the SD mode is selected, the specific software supplied with this prouct can not be used.