Filter
Top Products
205
Appendices
FIn case of surface clean
RTurn the camera off and attach the lens cap, or if
the lens is detached, attach a body cap to the camera.
In case of surface soiling
RContact a FUJIFILM dealer and request CCD
cleaning. Or see Starting CCD cleaning (➝p.205).
CAUTION
• Note that this option is not available at battery
levels less than or while shooting multiple
exposures.
• When cleaning the camera, always use the full
charged battery or AC power adapter AC-135VN
(sold separately) to prevent camera damage
should the mirror drop or the shutter close.
• If the battery runs low while the mirror is raised, a
beep will sound and the AF-assist illuminator will
blink to warn that the shutter curtain will close and
the mirror will lower in about two minutes. End
cleaning or inspection immediately.
MEMO
To return to normal operation without raising the
mirror, turn the camera off.
Starting CCD cleaning
Take great care to avoid scratching or damaging the CCD
during cleaning, as you will be responsible for the possibly
high cost of repairs (or replacement) by an authorized
FUJIFILM dealer.
AUse a blower (without a brush attached) to remove any
soiling on the CCD surface.
MEMO
Use a blower that does not have a brush attached.
Using a blower brush to clean soiling from the CCD
can scratch the CCD surface.
Continued Q
EHold the camera so that the sun shines on the CCD
and check the surface for dust.