Filter
Top Products
116 117
Nothing happens when I
use the camera switches
and dial.
No image appears when I
press the, “DISP” button.
There is no sound.
There is no picture or
sound on the TV.
• Camera malfunction.
• The Mode switch and Photography mode
dial has been moved to another setting.
• The battery exhausted.
• The Mode switch and Photography mode
dial has been moved to another setting.
• sounThe camera volume is set too low.
• The microphone was covered during
recording.
• The A/V cable is connected.
• The A/V cable is connected during movie
playback.
• The camera and TV are connected
incorrectly.
• The TV input is set to “TV”.
• The volume on the TV is set too low.
• Use the “POWER” switch to switch the
camera on again.
• Remove the battery, re-insert them and try
again.
• Load a new battery.
• Move the Mode dial to the correct setting.
• Adjust the volume.
• Take care not to cover the microphone
when recording.
• Disconnect the A/V cable.
• Connect the A/V cable correctly.
• Connect the TV and camera correctly.
• Set the TV input to “Video”.
• Adjust the volume.
Cause RemedyProblem
Troubleshooting
I can’t use the flash to take
pictures.
The flash will not charge.
The playback image is too
dark even though I used
the flash.
The image is blurred.
I cannot format the
SmartMedia.
I cannot erase all the
frames.
• The Mode switch and Photography mode
dial has been moved to another setting.
• The flash is set to Suppressed Flash
mode(The flash is closed).
• You pressed the shutter button while the
flash was charging.
• No compatible SmartMedia is loaded.
• The camera is set to Suppressed Flash
mode.
• The camera is set to Macro Photography.
• The battery is exhausted.
• The subject is too far away.
• Your finger covering the flash.
• The lens is dirty
• The lens is zoomed to telephoto in Macro
mode.
• The SmartMedia is write-protected.
• The frame is protected.
• Set the Mode switch and Photography
mode dial to the correct setting.
• Set the flash to Auto, Red-Eye Reduction or
Forced Flash mode(Pop the flash unit up).
• Wait until charging is completed before
pressing the shutter button.
• Load a new SmartMedia, erase a frame, or
remove the write-protection.
• Set the flash to Auto, Red-Eye Reduction or
Forced Flash mode.
• Cancel Macro Photography.
• Load a new battery.
• Move closer to the subject.
• Hold the camera correctly.
• Clean the lens.
• Cancel Macro mode.
• Remove the write-protection.
(Peel off the write-protect sticker.)
• Remove the frame protection.
Cause RemedyProblem