Filter
Top Products
7-2
Contents of the Setup Mode
No
Tolerance: No
No/10/15/20mm
Document: No
No
Sharpen Darken
Charactor Copy
Quality
--
Time:
0.2 to 29.8 sec
1.0 sec
Time:
27 values from 30 sec
1 to 1999 sec
Offset: Offset:
H:-2 to +3mm H: 0 mm
V:-2 to +3mm V: 0 mm
Offset: Offset:
H:-2 to +3mm H: 0 mm
V:-2 to +3mm V: 0 mm
Offset: Offset:
H:-2 to +3mm H: 0 mm
V:-2 to +3mm V: 0 mm
SCSI ID:
0/1/2/3/4/5/6/7 5
This section describes the contents of the setup mode.
No Item Description Selectable Default
parameters
1 Double feed check Specify the double feed detedtion. Double
feed is detected by checking the document
length and/or paper thickness.**
2 Length check Specify the document length to enable
=No/10/15/20 mm double feed detection set the document
length.
3 IPC pre-setting Scanner automatically sets the recom-
mended reading parameters. 3 sets of
parameters are available when IPC-4D is
not installed.
4
Resetting of abrasion
Reset abrasion counter.
counter
5 Pick start time Specify the time from document Insertion
setting to the start of picking. User can select
most comfortable Pick start time for the
job.
6 Time-out limit setting Specify the time the scanner waits for next
ducument insertion after last document
scanned.
7 ADF front offset Specify the horizontal and vertical offset of
setting* the front side image by ADF.
8 ADF back offset Specify the horizontal and vertical offset of
setting* the back side image by ADF.
9
Flatbed offset setting
* Horizontal and vertical offset of the FB
image is specified.
10 IPC status display The type of IPC option (IPC-4D) is
displayed.
11 SCSI ID setting SCSI ID is selectable.