Filter
Top Products
7-5
2. Setting double feed detection (Paper Length)
1 Press or and let the
scanner display Screen 42.
2 Press either the
or switch to set double feed detection according to paper length. The paper
length is checked using the difference between two consecutive sheets of paper fed from the ADF.
Each time either of these switches is pressed,the location of the blinking moves. When the
switch is pressed, the blinking moves from (1) to (3). When the switch is pressed, the blinking
moves in the opposite direction. However, if the setting by the host computer is valid, the location
of the blinking does not move when either switch is pressed.
(1) “No” is blinking: Paper thickness is not checked.
(2) “Yes” and “1” are blinking: Paper thickness is checked. However, a detected double feed
error is displayed on the screen only; processing is continued.
(3) “Yes” and “2: Stop” are blinking: Paper thickness is checked. When the double feed error is
detected, the scan processing is stopped. The error is then
reported to the host.
If you want to disable the double feed, select “No” then press
. Press to return.
After pressing the
, the scanner displays the screen 42-1.
3 Press either the
or switch to set
double feed detection (paper length).
When the
switch is pressed, the
blinking moves from (1) to (3). When the
switch is pressed, the blinking moves
in the opposite direction.
(1) The “10” is blinking: Threshold is 10mm
(2) The “15” is blinking: Threshold is 15mm
(3) The “20” is blinking: Threshold is 20mm
<Screen 42>
<Screen 42-1>