Filter
Top Products
48
• The Exposure Cable EL (supplied) should be connected.
• Only the single shot function (A or AS mode camera settings) should be set on the camera.
Rapid sequence shots are not possible.
• Use the Adapter EL (supplied) to provide the necesssary extension beyond the motor hous-
ing of the EL models for battery attachment. It is attached to the CFV in the same manner
as a battery, and the battery itself is then attached to the adapter as in the illustration.
ELX
For use with 500EL/ELM and 500/553ELX models:
• Make an ELX
setting.
• The Exposure Cable EL (supplied) should be connected.
• All exposures times, including the B setting, function correctly without having to alter
the “Exposure Time” setting.
• Rapid sequence shots are not possible.
• Use the Adapter EL (supplied) to provide the necesssary extension beyond the motor hous-
ing of the EL models for battery attachment. It is attached to the CFV in the same manner
as a battery, and the battery itself is then attached to the adapter as in the illustration.
Pinhole
For use with lenses/cameras with no shutter. Intended primarily for use in a studio en-
vironment where complete darkness can be achieved and exposures made accordingly
(also useful for ‘light painting’). In this mode the CFV uses the exposure time (as well
as other required stages in a capture sequence) set in the Capture Sequence dialog. e
back can be triggered either via the START (MENU/EXIT) button or from FlexColor (see
later section for full description of Capture Sequence settings procedure).
Flash sync
For use with non-modified 200 series models (together with C-lenses in C-mode), an
ArcBody, a FlexBody or view cameras with a Hasselblad adapter.
• Make a Flash sync
setting.
• The Flash sync input cable (supplied) should be connected to the Flash sync in terminal.
• All exposures times, including the B setting, function correctly without having to alter
the “Exposure Time” setting.
• Do not use a winder at rapid sequence setting.
SWC
For use with 903 SWC and 905 SWC models.
• Make an SWC
setting.
PLEASE NOTE: Due to the mechanical design of the SWC, pressing the exposure release button
too slowly may cause a faulty capture with a magenta cast. Either press the button much more
distinctly or alternatively change the setting from SWC to Flash sync and use the flash sync
cable to connect the lens to the CFV.
200
For use with modified 202, 203 and 205 models together with F-lenses or CF-lenses in
F-mode. (Only these three models can be modified for cable-free compatibility with
the CFV. Please contact your Hasselblad dealer for further information)
• Make a 200
setting.
• A Flash sync input cable should not be used.
• All exposures times, including the B setting, function correctly without having to alter
the “Exposure Time” setting.
• Do not use a winder at rapid sequence setting.
All Hasselblad EL models
All Hasselblad EL models except ELD
Adapter EL
Exposure Cable EL