Hasselblad 70480542 Digital Camera User Manual


  Open as PDF
of 140
 
119
H4D
43
5
21
Example of viewnder display
showing Flash set to Rear sync
as well as '- 1EV' exposure com-
pensation.
To access the controls:
1) Activate the camera and press the FLASH button once.
2) Turn the front control wheel to set the amount of compensa-
tion required:
• from+3EVthrough-3EV
• pressClr (AF button) to clear the setting quickly if required.
3) Turn the rear control wheel to set:
• normalsync(ashtriggeredjustaftertheshutteropens)
• rearsync(ashtriggeredjustbeforetheshuttercloses)
• ashmeasure(withnon-TTLashunitsorTTLunitsin
Manual mode)
4) The grip display shows the ash mode - Normal or Rear - in
the standard display.
5) When set to Flash Measure, a specic screen requests you to
press the AE-L button in order to make a reading. See below
for details.
Integral ash
The integral ash unit features the following specications:
Guide no. 12
Coverage 56º horizontal,
44º vertical
Maximum light fall-o at side centres - 1EV (50%)
Color temperature (full ash) 5,000 – 5,600º K
To raise the ash unit into its operative position, slide the ash-
unit catch backwards in the direction of the ash symbol. To
return the ash unit into its closed position, push down on the
top of the unit until it clicks back into place. The ash unit is
automatically activated when it is in the operative position and
de-activated when returned to its stored position.
The green LED ash symbol blinks in the viewnder when the
ash unit is charging and remains stationary when fully charged.
The ash output can also be adjusted for optimum light balance
in ll-ash situations.
Using the integral ash:
1) Slide the ash-unit catch backwards in the direction of the
ash symbol.
2) Press the FLASH button.
3) Choose between Normal or Rear sync by turning the rear
control wheel and the amount of compensation (if required)
by turning the front control wheel.
4) Press Save (ISO/WB ) button. Make an exposure.
FLASH
F
Clr
AF
R
FLASH
R
F
Save
ISO/WB
Note
For full coverage with the integral ash, use 80 mm or longer
lenses (without a lens shade).
Note
Do not use the integral ash together when another external
TTL ash unit is connected (and used in TTL or A mode).
1 2
3 4
 previous next