Filter
Top Products
Advanced Techniques
50
does not operate.
Note: The date search function is released when you press the STOP button during date
search mode.
Note: If the recorded time is less than 30 seconds, the date search function may not
operate normally.
Using Memory
The linear time counter memory stops a rewinding tape at approximately 0:00:00M. This
feature helps in locating a specific point in the tape to which you wish to return. An
example might be that you have recorded some tape that you have already watched,
you continue recording but do not care to watch the tape you recorded earlier. The
memory feature returns you to the beginning of the most recent recording.
1. Start recording or playback of a cassette. Press the COUNTER RESET button on the
remote control at the point to which you wish to return. The linear time counter clears to
"0:00:00".
2. Press the STOP button to stop playback, or press the start/stop recording and set the
CAM/OFF/VIDEO switch to VIDEO.
3. Press the DISPLAY button on the remote control so the linear time counter with
memory is displayed as shown in the figure.
4. Press the REW/REVIEW button and the tape stops at approximately where you reset
the linear time counter. This feature works in F.FWD as well.
Using the Wireless Remote Control
Use the wireless remote control to operate the camcorder from a distance. The PLAY,
F.FWD, REW, STOP, PAUSE (START/STOP) and ZOOM buttons on the wireless
remote control operate the functions of the corresponding buttons on the camcorder.
Aim the wireless remote control at the infrared receiver of the camcorder.