Filter
Top Products
English
148
During playback
An error message for
repair appears.
Perform repair following the instructions on screen.
Repair is possible when the DVD video camera/recorder is powered
by the AC adapter/charger. If you are using the HDD and have
detected an error in part of video file, a battery can also be used for
repair (except when the remaining battery level indicator is blinking).
It will take from a few minutes to several hours for repair. If you
wish to start recording immediately, remove the disc, and then
insert another disc: The removed disc can later be repaired by
connecting the AC adapter/charger.
28
Symptom Cause and Correction
Reference
page
Recognition of disc is
not complete.
Is disc dirty?
Use the provided disc cleaning cloth to clean it.
11
Pressing the playback
button will not start
playback.
Has the image been recorded by devices other than this DVD
video camera/recorder?
Playback of image recorded on devices other than this DVD video
camera/recorder may be impossible on this DVD video camera/
recorder.
74
Has scene been edited on a device other than this DVD video
camera/recorder?
If a scene recorded on this DVD video camera/recorder is edited
on a device other than this DVD video camera/recorder, playback
may not be possible on this DVD video camera/recorder.
No playback picture
appears on TV screen.
Is TV input selector set correctly?
Some TVs have multiple video input jacks. Check whether the
correct input was selected on TV to match the connected jacks. If
the DVD video camera/recorder is connected to VCR, set its
input selector to “external input (LINE)”.
113
Is the DVD video camera/recorder connected to TV correctly?
Check the connections.
112
Playback picture is
momentarily interrupted.
Is disc scratched or does dirt or fingerprint adhere to it?
Clean the disc.
11
Poor playback picture. Was the image input from analog VCR (VHS, 8 mm) and
recorded?
The problem may be improved if a VCR equipped with TBC
circuit is used for playback.
—
Playback picture is
greatly distorted.
Was recording of external input made with “Frame” specified?
Specify “Field” for “PHOTO Input” in record functions setup.
68
No sound. Is the TV volume control set correctly?
Adjust TV volume control, and be sure to adjust the volume on
TV.
113
Disc Navigation
thumbnails do not
appear.
Was the image recorded from AV input/output jack with
interference?
Record image with no noise or disturbance.
—
Symptom Cause and Correction
Reference
page