Filter
Top Products
English
167
When the DVD video camera/recorder is connected to PC:
Symptom Cause and Correction
Reference
page
No drive icon appears
on PC.
The DVD video camera/recorder is not turned on.
Check the power supply.
47
Turn PC off and then disconnect the PC connection cable. Turn
PC on again, and then use the PC connection cable to connect
the DVD video camera/recorder to PC.
Make sure the PC connection cable is completely plugged into
this DVD video camera/recorder.
Error occurs in playback
of DVD video camera/
recorder on PC.
If error occurs with USB connection, the transfer rate is not
sufficient. It is recommended that you use a USB terminal
conforming to USB2.0 when connecting the DVD video camera/
recorder.
138
Application is not
normally run on PC.
Turn the PC and DVD video camera/recorder off, and try again.
Error occurs during
writing to disc.
The temperature of DVD video camera/recorder is too high due
to continuous operation.
Disconnect the DVD video camera/recorder from PC once,
remove the disc from the DVD video camera/recorder, and then
turn it off. After a few moments, connect them again and write to
a brand-new disc.
Transfer of images
stops.
Connect the DVD video camera/recorder to another USB terminal
of PC. If your PC is a desktop type, it is recommended that you
use USB terminal on the back of PC. If you are using USB2.0
extended card, it is also recommended that you install the newest
version driver provided by each USB2.0 card maker.
DVD-RAM/R drive built
into PC cannot be used
after the provided
software has been
installed.
This problem may be solved if the software related to DVD-RAM/
R of your PC is upgraded, or if the UDF driver is uninstalled.
However, with Windows
®
Me / 2000 Professional, uninstalling the
UDF driver will make it impossible for the JPEG stills recorded on
DVD-RAM of this DVD video camera/recorder to be read by the
PC.
DVD-R disc cannot be
played back on DVD-
MovieAlbumSE.
DVD-MovieAlbumSE does not support playback or data read on
DVD-R disc: Use generally available DVD video playback
software to play back DVD-R disc on PC.
140
Error appears when
starting DVD-
MovieAlbumSE.
Make sure that your PC display adapter (video card) conforms to
DirectX8.1. 138
Video written to hard
disk of PC cannot be
edited on DVD-
MovieAlbum copy tool.
DVD-MovieAlbumSE cannot edit DVD-VR data stored on hard
disk of PC: Copy the data to another DVD-RAM disc and then
edit it.
Movies are not
recognised by
application in PC.
Make sure the power switch of this DVD video camera/recorder is
set to “O” or “N”.