Hitachi DZ-GX20E Camcorder User Manual


 
English
53
Note:
See “Check 1” on page 155 when recording movie is
not possible.
See “Check 4” on page 155 if it takes some time
before recording is possible.
See “Check 5” on page 156 if the DVD video camera/
recorder does not operate.
See page 55 for on-screen information display.
It is recommended that you use DVD-RAM disc from
which recorded contents can be deleted.
Sound is recorded from the stereo microphone on the
front of DVD video camera/recorder: Take care that
this microphone is not blocked.
You can press the REC button immediately after the
DVD video camera/recorder enters the recording
pause status, but no further recording can be made
while “DISC ACCESS” is being displayed.
Recording will restart after the message disappears.
Do not turn power off while message “DISC ACCESS”
is being displayed.
Take care that power is not interrupted while the
ACCESS/PC indicator is blinking.
The minimum recordable time of movie is
approximately 3 seconds.
See page 98 for setting of Record LED (recording
indicator) On/Off.
For various functions available during recording, see
“Setting Up Camera Functions” on page 85.
Hitachi cannot be responsible for video and audio that
cannot be recorded or edited because of any defect.
The power switch can be changed over even during
recording, but the operation will not be changed.
Each time the DVD video camera/recorder enters the
recording pause status, the counter display will be
reset to “0:00:00”.
It is recommended that you set the LOCK switch to L
(the upper position) to prevent the power switch in the
O” position from accidentally moving to “N” position.
Do not insert a non-finalised DVD-R disc into another
DVD device: Doing so could cause the disc to
become unusable (except in the case of the devices
that have a function that can play back a disc that has
not been finalised on this DVD video camera/
recorder).
When using an unformatted DVD-R disc, it is
necessary to format it on this DVD video camera/
recorder (see page 49).