EN83
Indications Function
Displays the battery remaining power.
Remaining power level: high
Remaining power level: exhausted
As the battery power comes close to nil, the battery indicator blinks.
When the battery power is exhausted, power turns off automatically.
Appears when no tape is loaded. (੬ pg. 12)
Appears when the erase protection tab is set to “SAVE” while the Power
Switch is set to “ ” or “ ” and the VIDEO/DSC Switch (GR-DVL915/
DVL815/DVL510 only) is set to “VIDEO”.(੬ pg. 12)
Appears if dirt is detected on the heads during recording. Use an optional
cleaning cassette. (੬ pg. 86)
Appears if condensation occurs. When this indication is displayed, wait
more than 1 hour until condensation disappears.
Appears if a tape is not loaded when the Recording Start/Stop Button or
SNAPSHOT Button is pressed while the Power Switch is set to “ ” or
“ ” and the VIDEO/DSC Switch (GR-DVL915/DVL815/DVL510 only) is
set to “VIDEO”.
Appears when the tape ends during recording or playback. (੬ pg. 70)
Appears if a tape in another format is loaded.
●Appears when the date/time is not set. (੬ pg. 11)
●Appears when the built-in clock battery runs out and the previously set
date/time is erased. Consult your nearest JVC dealer for replacement.
Appears for 5 seconds after power is turned on if the lens cap is attached.
Appears if Audio Dubbing is attempted on a blank portion of a tape.
(੬ pg. 66)
●Appears if Audio Dubbing is attempted on a tape recorded in the LP
mode. (੬ pg. 66)
●Appears if Audio Dubbing is attempted on a tape recorded in 16-bit
audio. (੬ pg. 66)
●Appears if A. DUB (e) on the remote control is pressed when the erase
protection tab is set to “SAVE”.(੬ pg. 66)
Warning Indications
TAPE!
TAPE END
SET DATE/TIME!
CHECK TAPE’S ERASE
PROTECTION TAB
HEAD CLEANING
REQUIRED USE
CLEANING CASSETTE
CONDENSATION
OPERATION PAUSED
PLEASE WAIT
DIFFERENT
FORMATTED TAPE
A. DUB ERROR!
<CANNOT DUB
ON A LP RECORDED
TAPE>
<CANNOT DUB
ON A 16BIT
RECORDING>
<CHECK TAPE’S ERASE
PROTECTION TAB>
A. DUB ERROR!
CONTINUED ON NEXT PAGE
LENS CAP