Filter
Top Products
EN 9
Master Page: Right-start
AUTOMATIC DEMONSTRATION
Automatic Demonstration takes place when “DEMO
MODE” is set to “ON” (factory-preset).
Ⅲ Automatic Demonstration starts when there is no
operation for about 3 minutes after the Power
Switch is set to “A” or “M” and no cassette is in
the camcorder.
Ⅲ Performing any operation during the
demonstration stops the demonstration
temporarily. If no operation is performed for more
than 3 minute after that, the demonstration will
resume.
Ⅲ “DEMO MODE” remains “ON” even if the
camcorder power is turned off.
To cancel Automatic Demonstration
1
Set the Power Switch to “M” while pressing down
the Lock Button located on the switch.
2 Open the LCD monitor fully, or pull out the
viewfinder fully.
3 Press MENU. The Menu Screen appears.
4 Press + or – to select “s SYSTEM”, and press
SET/SELECT. The SYSTEM Menu appears.
5 Press + or – to select “DEMO MODE”, and press
SET/SELECT. The Sub Menu appears.
6 Press + or – to select “OFF”, and press SET/
SELECT.
7 Press + or – to select “BRETURN”, and press SET/
SELECT twice. The normal screen appears.
NOTE:
Slide the lens cover down to see the actual changes
of the Automatic Demonstration activated on the
LCD monitor or viewfinder.
Automatic Demonstration
ST
M SY E
DEM– MO DE O
NO
OFF
Power Switch
Lock Button
MENU Button
Sub Menu
SET/SELECT Button
+, – Button
GR-DVP10PAL.book Page 9 Tuesday, January 6, 2004 10:55 AM