Filter
Top Products
EN13
OF
F
FADER
/ W I PE
AM AEPROGR
ACAMER
LMANUA
MSYSTE
DSC
END
AYDISPL
C
AN E
W. BAL
RE NEON SC
LCD/TV
UAOT
IMETDATE/
T I ME CODE
CLOCK
ADJ .
–
–
– FFO
25 ’01
CED
30
PM
:5
NRETUR
CLOCK
ADJ .
25 ’01
CED
30
PM
:5
Date/Time Settings
The date/time is recorded onto the tape at all times, but its
display can be turned on or off during playback
(੬ pg. 44, 45).
1
Set the Power Switch to “ ” while pressing down
the Lock Button located on the switch, then open
the LCD monitor fully or pull out the viewfinder
fully. The power lamp lights and the camcorder is
turned on.
2
Press MENU. The Menu Screen appears.
3
Press + or – to select “ DISPLAY”, and press SET/
SELECT. The DISPLAY Menu appears.
4
Press + or – to select “CLOCK ADJ.”, and press SET/
SELECT. “Month” is highlighted.
Press + or – to input the month, and press SET/
SELECT. Repeat to input the day, year, hour and
minute. Press + or – to select “ RETURN”, and
press SET/SELECT twice. The Menu Screen closes.
Built-in Clock’s Rechargeable Lithium Battery
To store the date/time in memory, the clock’s rechargeable
lithium battery is integrated in the camcorder. While the
camcorder is connected to an AC outlet using the AC
Power Adapter/Charger, or while the battery pack attached
to the camcorder continues to supply power, the clock’s
rechargeable lithium battery is always charged. However,
if the camcorder is not used for approx. 3 months, the
clock’s lithium battery will become discharged and the
date/time stored in memory will be lost. When this occurs,
first connect the camcorder to an AC outlet using the AC
Power Adapter/Charger for over 24 hours to charge the
clock’s rechargeable lithium battery. Then perform the
date/time setting before using the camcorder.
Note that the camcorder can be used without setting the
date/time.
NOTE:
Even if you select “CLOCK ADJ.”, if the parameter is not
highlighted the camcorder’s internal clock continues to
operate. Once you move the highlight bar to the first
date/time parameter (month), the clock stops. When you
finish setting the minute and press SET/SELECT, the date
and time begin operation from the date and time you
have just set.
Display
MENU Button
Power Switch
Lock Button
DISPLAY Menu
Power lamp
SET/SELECT Button
+, – Button