Filter
Top Products
E20
@@@@@@
Connecting an MO drive unit
2. Before recording (continued)
It is possible to output image data stored in the main unit memory to an MO drive unit. ( ੬ Page
36 Saving images from the memory to an MO disk)
To directly connect the MO drive to the main unit, set the dip switches on the rear of the main unit
as shown below.
MEMO
• The image data outputted to an MO drive will be 1360 × 1024 pixels, regardless whether the monitor
in use is VGA or SXGA, or whether the VGA mode is set to FINE or DRAFT.
• The maximum allowed length of the SCSI cable is 3m.
• When connecting an MO drive to a PC, separate setting of the SCSI ID is required.
( ੬ Page 64 7. Connecting to a PC)
• It is not possible to simultaneously output the image data to a printer and MO drive.
SEE INSTRUCTION MANUAL
POWER
DC IN
REMOTE
MONITOR
LENS
FREEZE
PLAY
SETDOWN
AW/SELSEND
SCSI
UPMENU
MODE
REC
ON 1 2 3 4
ON 1 2 3 4
(SCSI : 7)
Do not set the ID of the MO drive side to other than
7.
Dip switches
SCSI terminal