Filter
Top Products
E21
Connecting a printer
It is possible to directly output image data stored in the main unit memory to a printer. ( ੬ page
37 Outputting images from the memory to a printer)
When directly connecting the main unit to a printer, set the dip switches on the rear of the main
unit as shown below.
MEMO
• The image data outputted to a printer will be 1360 × 1024 pixels, regardless whether the monitor in
use is VGA or SXGA, or whether the VGA mode is set to FINE or DRAFT.
• The maximum allowed length of the SCSI cable is 3m.
• When connecting an MO drive to a PC, separate setting of the SCSI ID is required.
( ੬ Page 64 7. Connecting to a PC)
• It is not possible to simultaneously output the image data to a printer and MO drive.
SEE INSTRUCTION MANUAL
POWER
DC IN
REMOTE
MONITOR
LENS
FREEZE
PLAY
SETDOWN
AW/SELSEND
SCSI
UPMENU
MODE
REC
ON 1 2 3 4
POWER
ALARM SHEET
PAPER
DATA
OPEN
CP700DSA
MITSUBISHI
ONLINECOPY
& CUTPAPER FEED
]
ON 1 2 3 4
(SCSI : 7)
Set the ID of the printer side to other than 7.
Dip switches
SCSI terminal