Filter
Top Products
E28
@@@@@@
3. Settings and adjustments for recording (continued)
Monitor adjustment
The color contrast, brightness, etc. are adjusted by sending built-in color bar signals of the main
unit to the PC monitor.
1.
Depending on the system, set the MONITOR mode to
VGA or SXGA.
(Set using the main unit dip switches)
Monitor settings ( ੬ page 24)
2.
Connect the monitor and MONITOR terminal.
3.
Set dip switches 3 and 4 on the rear of the main unit to
ON.
MEMO
Turn the power off before setting the dip switches. Setting the
switches with the power on will not change the settings.
4.
Turn the main unit power on.
5.
Adjust the video monitor.
MEMO
• For the adjustment method, see the instruction manual of
the video monitor.
• The peak level of the color bar is et to 0.7V. To change the
setting to 0.58V, select BAR LEVEL in the SYSTEM SET-
TING screen ( ੬ Page 58).
6.
When completed, turn off the system power., then set
dip switch 4 to OFF.
Dip switches
MONITOR terminal
SEE INSTRUCTION MANUAL
POWER
DC IN
REMOTE
MONITOR
LENS
FREEZE
PLAY
SETDOWN
AW/SELSEND
SCSI
UPMENU
MODE
REC
ON 1 2 3 4
ON 1 2 3 4