Filter
Top Products
12
Getting Started
Rear
O
[MONITOR OUT] Monitor Video Signal
Output Terminal (RCA)
This is an output terminal for composite video
signals (1 V (p-p), output impedance of 75 K).
Use this terminal to connect to devices such as a
video monitor.
This terminal is used for adjusting the camera
angle during installation. (A Page 19)
Note:
● Use the K [MONITOR OUT] switch to select
the availability of output as well as the signal
system. When the switch is changed, press
the L Reset button to reboot the unit.
● When using the [MONITOR OUT] output, set
the privacy mask to AOffB. (A Page 56)
P [10BASE-T/100BASE-TX]
Use this terminal to connect to the network via a
LAN cable.
This product supports PoE (IEEE802.3af) and
therefore can be used without a power cable.
PoE: class 2 (VN-V25U)
class 0 (VN-V26U)
(A Page 17)(A Page 19)
Q [ALARM INPUT/OUTPUT] Alarm Input/
Output Terminals
Use these terminals to connect to an external
alarm device.
(A Page 20)
R [AC24V] Power Input Terminal
Use this terminal to connect to an AC 24 V,
50/60 Hz power supply.
(A Page 17)
S Fall Prevention Wire Mounting Screw
(M3 x 6 mm)
Use this screw to mount the fall prevention wire.
(
A
Page 21)
T [AUDIO OUT] Audio signal output terminal
(mini jack R3.5 mono) (VN-V26U only)
Outputs audio (analog) received from a
computer.
Does not output audio from the F built-in-
microphone.
CAUTION
: NEVER USE
PoE
AND
AC 24V
AT THE SAME TIME
DO NOT CONNECT TO THE TELEPHONE NETWORK
SEE INSTRUCTION MANUAL
CLASS 2 ONLY FOR USA
ISOLATED POWER ONLY
FOR EUROPE AND OTHER
MONITOR
OUT
AUDIO OUT
10BASE-T/
100BASE-TX
PUSH
OUTPUT
ALARM
INPUT
2
AC24V
1
PoE
G 2 1 2 1
CAUTION
: NEVER USE
PoE
AND
AC 24V
AT THE SAME TIME
DO NOT CONNECT TO THE TELEPHONE NETWORK
SEE INSTRUCTION MANUAL
CLASS 2 ONLY FOR USA
ISOLATED POWER ONLY
FOR EUROPE AND OTHER
MONITOR
OUT
10BASE-T/
100BASE-TX
PUSH
OUTPUT
ALARM
INPUT
2
AC24V
1
PoE
G 2 1 2 1
VN-V25U
VN-V26U
R
Q
R
Q
SS
O
P
T
PO
VN-V25U_26U_EN.book Page 12 Friday, January 18, 2008 2:56 PM