Filter
Top Products
46
Setting Using Internet Explorer
Audio Page (VN-V26U only)
This page is for setting the audio parameters.
This page can be used during access using AadminB or AoperatorB
●
To enable the new settings, press the
[OK]
button.
Setting (continued)
A Duplex Mode For setting the audio transmission method.
When half duplex is selected, audio sent to computers from the camera is
muted when audio is transmitted from a computer to the camera.
When full duplex is selected, you can send audio to the camera from a
computer while listening to audio sent to computers from the camera
[Set values: Half Duplex, Full Duplex]
Note:
● When AFull DuplexB has been set, there may be cases where echos will
happen as a result of the audio sent from the computer gets picked up by
the VN-V26U’s internal mike. In that case select AHalf DuplexB.
B Mike Gain For specifying the gain value for the built-in microphone of VN-V26U.
[Set values: 0 dB, 20 dB, 26 dB, 32 dB]
A
B
VN-V25U_26U_EN.book Page 46 Friday, January 18, 2008 2:56 PM