Filter
Top Products
95
Note:
● Settings of the built-in-viewer are stored in the file named Cookie.
A Receive Setup For specifying settings related to receiving of audio sent from VN-V26U.
Receive For specifying whether to receive audio.
Select AOnB to to receive audio.
Note:
● A mechanical sound (that sounds when infrared ray filter is being
plugged or unplugged) will sound when black-and-white mode is
been switched. During the period where the sound is active, other
sounds from VN-V26U will be muted.
Stream For selecting the stream protocol of the received audio.
When AHTTPB is selected, lost packets are recovered via resending.
When AMulticastB is selected, the audio of VN-V26U may be monitored
using a multiple number of client PCs. When receiving data via multicast,
start multicast sending on the [Streaming] page of the VN-V26U unit.
Caution:
● When the built-in viewer is launched with AMulticastB specified, a
Windows firewall warning may appear. In this case, select AunblockB
and proceed.
● If AblockB is selected, the Windows firewall will block the multicast
stream and playback of multicast by the viewer will fail.
Multicast IP
Address
You can change the multicast IP address.
The default address is 225.0.3.1
Specify the same value as the parameter that is set on the [Streaming]
page of VN-V26U.(A Page 65)
Multicast Port You can change the multicast port number.
The default port number setting is 39152.
Specify the same value as the parameter that is set on the [Streaming]
page of VN-V26U.(A Page 65)
B Speech Setup For specifying settings for sending audio to VN-V26U from the computer.
Destination Port You can change the destination port for sending audio to VN-V26U from
the computer. The default port number setting is 49298.
Operator
password
For entering the operator password when sending audio to VN-V26U
from the computer.
C HTTP Port You can change the port number that is used to get audio via HTTP. The
default port number setting is 80.
Specify the same value as the parameter that is set on the Protocol page
of VN-V26U. (A Page 63)
D OK Saves the changed settings.
Click the [OK] button to enable the new settings and restart the built-in
viewer after closing the setting window.
E Cancel Cancels the changed settings and closes the setting screen.
VN-V25U_26U_EN.book Page 95 Friday, January 18, 2008 2:56 PM